CURAでプリンタ設定の「プリンタ」タブの「G-Codeの開始」に
; Script based on an original created by tjjfvi (https://github.com/tjjfvi)
; An up-to-date version of the tjjfvi's original script can be found
; here: https://csi.t6.fyi/
; Note - This script will only work in Cura V4.2 and above!
; --- Global Settings
; layer_height = {layer_height}
; smooth_spiralized_contours = {smooth_spiralized_contours}
; magic_mesh_surface_mode = {magic_mesh_surface_mode}
; machine_extruder_count = {machine_extruder_count}
; --- Single Extruder Settings
; speed_z_hop = {speed_z_hop}
; retraction_amount = {retraction_amount}
; retraction_hop = {retraction_hop}
; retraction_hop_enabled = {retraction_hop_enabled}
; retraction_enable = {retraction_enable}
; retraction_speed = {retraction_speed}
; retraction_retract_speed = {retraction_retract_speed}
; retraction_prime_speed = {retraction_prime_speed}
; speed_travel = {speed_travel}
; X5SA Pro Start Code
G21
G90
M82
M107 T0
M140 S{material_bed_temperature_layer_0}
M104 S{material_print_temperature_layer_0} T0
M190 S{material_bed_temperature_layer_0}
M109 S{material_print_temperature_layer_0} T0
G28
G92 E0G28 ;Home
G1 Z15.0 F6000 ;Move the platform down 15mm
;Prime the extruder
G92 E0 ;Reset Extruder
G1 F200 E3 ;Extrude 3mm
G1 Y1 Z0.3 F200 ;Move Y1 Z0.3
G1 X120 F200 E10 ;clean-up
G1 X75 F200 E15 ;clean-up2
G92 E0 ;Reset Extruder Againと追加すると、いいらしい。
2021/02/09
「ヘッド清掃」は印刷する前にベッドの手前側に樹脂を塗りつけるらしいので手前でクリップを止めている場合は注意。
※手前のクリップの針金が吹っ飛びました！
手前にクリップがある場合は・・・XとYを入れ替えて・・・こうですね。
G28 ;Home
G1 Z15.0 F6000 ;Move the platform down 15mm
;Prime the extruder
G92 E0 ;Reset Extruder
G1 F200 E3 ;Extrude 3mm
G1 X1 Z0.3 F200 ;Move X1 Z0.3
G1 Y120 F200 E10 ;clean-up
G1 Y75 F200 E15 ;clean-up2
G92 E0 ;Reset Extruder Again所感
格安３Dプリンタだから失敗して壊れても・・・また買えばいいや
そう思ってたけど、失敗しすぎかな？